zoom »

Synthetic pumps stations Wastewater and sewage pumping station for drainage and pressure drainage, outside the building as pumps station in accordance with EN 752.

• Small sump diameter (625 mm)
• Flexible utilisation due to different installation heights
• Inlet connection is included with DN 100 as a standard
• Complete through integrated fittings and seals
• Can be walked over or driven over, depending on the covering (accessories)
• Also with macerator pumps Wilo Drain MTS 40/21...27

Wilo DrainLift WS 625 is available in 4 lengths: 1200, 1500, 1800 and 2100 mm. The sump can be equipped with a standard cover that can be walked on as well as Class A (can be walked on) or Class B/D (can be driven over) covers.

• Maximum pressure in the pressure pipe 6 bar in conjunction with MTS 40, other pumps 4 bar
• Synthetic pumps station made of recyclable PE
• Highest degree of upward pressure reliability and inherent stability by means of finning up to a ground water level above the entire sump height (upper edge of site)

• PE sump with internal pipework including coupling sleeve slider 1 ¼" and non-return valve (integrated in pump with TMW 32/11)
• Seal mounted for inlet DN 100
• Seal mounted for ventilation/electrical connection (DN 100).
• Seal mounted for pressure pipeline (DN 40 / Ø50).
• Pump (including floor supporting foot with MTS 40) with matching discharge pipe
• Installation and operating instructions.

Choice of switchgear and level probe as accessories.

Recommendations for electrical accessories are described in the "Wilo Drain electrical accessories" chapter.